Radiant DIAGNOCODE SM 20015 Instruction Manual - page 9
P.C.B. SM 20015 –boiler settings
6
Parameter
3
setting: HEATING TEMPERATURE SETTING
To modify the
Parameter value
:
a. Put ON/OFF button
1
in OFF position (
);
b. Push pad
6
and
simultaneously and keep them pressed;
c. Put ON/OFF button
1
in ON position (
)
and wait until the display shows
-
;
d. Release pad
6
and
;
e. Keeping pad
5
pressed, press pad
6
and select parameter no.
;
f. Release service pad
5
; press and release service pad
5
;
g. The display
will show the parameter value to be set or modified;
h. Press pad
6
or
to modify (increase or decrease) the parameter value
STANDARD from 30 to 80°C,
REDUCED from 25 to
40°C ;
i. Press and release service pad
5
to confirm setting;
j. The display will show parameter no.
;
k. Position ON/OFF button
1
first in OFF position (
) and back to ON position (
);
Parameter “
4
” setting: PUMP SETTING IN HEATING MODE
To modify the
Parameter value
:
a. Put ON/OFF button
1
in OFF position (
);
b. Push pad
6
and
simultaneously and keep them pressed;
c. Put ON/OFF button
1
in ON position (
)
and wait until the display shows
-
;
d. Release pad
6
and
;
e. Keeping pad
pressed, press pad
6
and select parameter no.
;
f. Release service pad
; press and release service pad
;
g. The display
will show the parameter value to be set or modified;
h. Press pad
6
or
to modify (increase or decrease) the parameter value
STANDARD (pump overrun),
PERMANENT (pump
ON all the time);
i. Press and release service pad
to confirm setting;
j. The display will show parameter no.
;
k. Position ON/OFF button
1
first in OFF position (
) and back to ON position (
);
PL
0
00
01
3
3
PL
0
00
01
4
4