Radio Terminal TK20 User Manual - page 3
5. Operation Commands Guide
5.1 Set APN:
(VERY IMPORTANT AND MUST BE DONE 1ST) For the
device to send data to the server, this command MUST be enabled.
SMS:
*apn*AXXX*BXXX*CXXX*
This command sets the telecom Access
Point Name. BXXX refers to user name, CXXX refers to password.
If there is no user name and password required, send as
*apn*AXXX*
If there is user name but no password required, send as
*apn*AXXX* BXXX*
APN information can be checked on local telecom website.
You will receive the following text: "Notice: APN is set to XXX. User name: XX.
Password: XX”
5.2 Registering the “Master” Controller
SMS to the device:
*master*123456*+1XXXXXXXXXXXX*
, (For
instance, master controller phone number is +1XXXXXXXXXXXX. +1 refers to
the country code. XXXXXXXXXXXX is the cellphone number. Please make sure
country code is included, and digit 0 is not needed before cell phone number)
Device Response: "Notice: Cell Phone # xxxxxxxxxx is set to master
controller, the password is 123456.” (The device has a default password of
“123456” to initially program in your PDA/Phone.
NOTE: The device will ONLY listen and respond to instructions from this
number unless you choose to turn on the multi controller function and open
the device to any cell phone number.
5.3 Changing the Password:
SMS:
*password*654321*
(654321 refers to new password)
You will receive the following text: "Notice: The password change is
successful for +1XXXXXXXXXX. The new password is 654321.”
Note: Changing password command has to be sent from master controller
number.
Радиотерминал 121059, Москва, 1-й Можайский тупик, д. 8а, стр. 1, этаж 2 тел. : +7 (499) 641-0464 +7 (812) 600-6040
www.radioterminal.ru info@radioterminal.ru