Radionics K6100 User Manual - K6100-Cnc
K6100-CNC
Initialize/Download to Site
K6100-CNC User Guide
© 2001 Radionics
Page 11
17317 Ver 1.2/48569B
You can now choose to perform a download to an individual door controller, or to all door controllers on
a site. Select the correct Door Controller from the list (or select All to download to all door controllers
on the site).
5.
Choose OK to begin the download operation.
A download occurs in two stages - firstly from the PC to the CNC, and secondly from the CNC to the
door controllers. The first stage will occur relatively quickly, the second more slowly. The time required
for both however is dependent on the size of the Readykey for Windows system (primarily the number
of keyholders), and the time for the second phase is dependent on the speed and type of
communications link in place between the CNC and the site.
During the first stage, Readykey for Windows will indicate the % Complete, and the CNC will display an
increasing update count of the form:
SITE sss*nnnnn
When the % Complete reaches 100%, then a ‘Download Complete’ message on the PC will be shown.
It is important to realize that it is only the download to the CNC which is complete at this point.
The second stage of the download begins at the same time as the first, but will normally take longer to
complete. As the CNC transfers the updates to the site, the CNC display will now decrease to until it
shows:
SITE sss*00000
for a dial-up site, or:
** MONITORING **
or a non-dial-up site.
6.
At this point you should confirm the downloads success by verifying that keyholders can gain access as
programmed through doors on the door controller/site.