Rain Bird PAR+ES Installation Manual - page 15
General Installation Instructions
It is very important that the decoders be installed
properly since most of the system will be underground
and therefore not easy to access should any alterations
or repairs be required Refer to instructions below for
proper installation techniques
Stripping The Maxi Wire
NOTE:
!
Use only a U F safety stripper tool as
manufactured by King Safety Products to
remove the outer PE jacket on the Maxi wire
It is the only tool that will remove the outer
jacket of the Maxi wire while minimizing
potential damage to the insulation on the
inner conductors
Slide 4” to 6” of the Maxi wire out through the hole
1.
in the back of the safety stripper
Make sure the cable is on it’s edge and gently
2.
apply even pressure with your thumb on top of
the tool
Firmly draw the tool back along the cable in one
3.
motion while maintaining light pressure with
your thumb
Turn the cable on it’s opposite edge and repeat
4.
the process
Clip off the loose outer pieces of PE jacket with
5.
linesman’s pliers
Remove the inner insulation with a properly sized
6.
wire stripper for the gauge cable you are working
with to make the Maxi wire splice, Red to Red and
Black to Black
NOTE:
!
It is advisable to test the above
method on a small piece of scrap Maxi wire
to familiarize yourself with the amount of
pressure to apply consistently remove a very
thin strip of the jacket in one motion without
damaging the inner insulation
Wire Splices
Gently twist two wires together using linesman’s
1.
pliers No more than four twists are required
NOTE:
!
Twisting the wires in excess can
fracture the conductors
Firmly hand-tighten the appropriate size wire nut
2.
onto the twisted wire and push it into the DBY or
DBR connector as far as possible
Snap the cap securely
3.
Valve Boxes at Splices
Place splices in a 12” x 18” rectangular valve box
1.
Provide three to four feet of excess wire in the
2.
valve box so that splices may easily be brought
above ground for troubleshooting
Clearly mark all wire splices with their routing
3.
direction or the holes they feed
Decoder Controller Installation
Decoder Wiring Procedure - Primary Path
Connect red wire of Equip side of MSP-1 to
1.
terminal 1A of DIB
Connect black wire of Equip side of MSP-1 to
2.
terminal 1B of DIB
Connect red wire of Line side of MSP-1 to red wire
3.
of Primary path
Connect black wire of Line side of MSP-1 to black
4.
wire of Primary path
NOTE:
!
Color coding of the wires can be
an invaluable troubleshooting tool in the
future
Connect the other end of the red wire of the
5.
Primary path to one (1) of the blue decoder
wires
Connect the other end of the black wire of the
6.
Primary path wire to the other blue decoder wire
NOTE:
!
If you are continuing the wire path to
another decoder, then connect a new wire to
the decoder in steps 5-6 and run the other
end of the new wire to the next decoder
PAR+ES Installation Manual
13
635778 Rev B (PAR+ES installation manual (1of2 ENG)) source.indd 13
9/2/2008 4:09:49 PM