Raisecom RC513 User Manual - 7. Dip-Switch Configuration
Beijing Raisecom Science & Technology Co., Ltd.
7. DIP-switch Configuration
7.1. Explanation for SW20 Setup
SW20 switch has 8 bits and the functions for each bit are as follows in sequence:
Auto-negotiation enable/disable, rate 100M/10M, full duplex/half duplex, reserved
(vacant), frame length 1916 bytes/1536 bytes, remote network management
enable/disable, reserved (vacant), Fault-pass-through disable/enable.
Switch Contents
Status
Configuration Details
ON
RJ45 is configured as manual setup
1
RJ45 auto-sensing or manual setup
OFF
RJ45 is configured as auto sensing
ON
RJ45 manual setup: bit rate is 10M
2
RJ45 manual 100M/10M setup
OFF
RJ45 manual setup: bit rate is 100M
ON
RJ45 manual setting: Half duplex
3
RJ45 manual setup:
Full Duplex/Half Duplex
OFF
RJ45 manual setting: Full duplex
4 Vacant
(Reserved)
ON
Over-sized frame up to 1536 bytes
5 Over-sized
frame
configuration
OFF
Over-sized frame up to 1916 bytes
ON
Disable remote network management
6
Remote network management
enable/disable
OFF
Enable remote network management
7 Vacant
(Reserved)
ON
Enabled: If the optical link is disconnected,
the RJ45 interface will be disabled
8 Fault-pass-through
disable/enable
OFF
Disabled: host RJ45 will always work
Note: When SW20-1 is OFF (auto-sensing status)
,
SW20-2 will be disabled.
7.2. Explanation for SW21 Setup
SW21-1 SW21-2
Module
Types
OFF ON RC513/514-FE-S1
ON OFF
RC513/514-FE-S2
12