Raisecom RC513 User Manual - page 7
Beijing Raisecom Science & Technology Co., Ltd.
4. Construction & Indicator
4.1.
Front view and indicators
4.1.1. The Indicators on the Front Panel
RLK
FDX
COL
PWR
TLK
ACT
LNK
ACT
RMD 100M
Optical RX Link
Optical Data
TX/RX Action
ETH Data
TX/RX Action
Optical TX Link
Bit Rate
Duplex mode
/Collision
Power Supply
Remote
Equipment
4.1.2. The Definition of Indicators
Interface
Indicator
Name
Indicator
The Status Explanation
Optical Receive
Link
RLK
ON: Optical receive link works in good condition;
OFF: Optical receive link fails.
Optical
Transmit Link
TLK
ON: Optical transmit link works in good condition;
OFF and RLK ON: Optical transmit link fails.
Optical
Interface
Optical Data
Active
ACT
Flashing: Transmitting data in Optical interface.
Remote
Management
Device
RMD
ON: Remote media converter supports remote SNMP
management;
OFF: Remote media converter does not support remote SNMP
management.
Fast flashing: host and remote-end managed;
Slow flashing: remote-end management prohibited by the
remote-end device, or at the status of fault-pass-through
Duplex Mode
/Collision
FDX/COL
ON: RJ45 works at full duplex mode;
OFF: RJ45 works at half duplex mode;
Flashing: Half duplex and collision occurs.
RJ45 Link
Receive and
Transmit
LNK/ACT
ON: RJ45 works in normal conditions;
OFF: RJ45 link fails;
Flashing: Transmitting data in RJ45 interface.
RJ45 Interface
Bit Rate
100M
ON: Rate is 100M; OFF: Rate is 10M.
6