Raisecom RC513 User Manual - 8. Network Management
Beijing Raisecom Science & Technology Co., Ltd.
8. Network Management
8.1. Card/Module Information Review
With network management software, the status of RC513/RC514 series can be reviewed
at the host site, and controlled/configured. The status information on “Show Module Info”
is as follows:
No. Status Name/Control & Configure Items
Options
Control & Configure Features
1
Module type
S1, S2
Uncontrollable, non-configurable
2 Fault-Pass-Through
Enable/disable
Configurable
3
Remote network management (Only used for RC514)
Enable/disable
Configurable
4
Loop back control (Only used for RC514)
Perform/No perform
Controllable
5
Loop back result (Only used for RC514)
Success/failure
Uncontrollable, non-configurable
6
Frame length
1916B, 1536B
Configurable
7
Receive rate (Only used for RC514)
N*32kb/s
N is Configurable
8
Transmit rate (Only used for RC514)
N*32kb/s
N is Configurable
9
Module voltage beyond upper limitation (Only used for
RC513)
Normal/beyond upper
limitation
Uncontrollable, non-configurable
10
Module voltage beyond lower limitation (Only used for
RC513)
Normal/beyond lower
limitation
Uncontrollable, non-configurable
11
Module temperature (Only used for RC513)
Actual temperature
Uncontrollable, non-configurable
12
RJ45: Link status
Up, Down
Uncontrollable, non-configurable
13 RJ45:
auto-negotiation
Enable/manual
Configurable
14
RJ45: control
Turn on/off
Configurable
15
RJ45: duplex status
Full/half duplex
Configurable
16
RJ45: rate
10M, 100M
Configurable
17
Optical Interface: transmit Link
Up, Down
Uncontrollable, non-configurable
18
Optical Interface: receive Link
Up, Down
Uncontrollable, non-configurable
19
Optical Interface: control
Turn on/off
Uncontrollable, non-configurable
20
Optical Interface: signal
Normal/abnormal
Uncontrollable, non-configurable
8.2. Module Configuration
Options such as receiving rate, transmitting rate and RJ45 interface, etc. can be
configured through “Configure Card”.
8.3. Loop-back Test
Modules in the host site can perform the test of loop-back enable/disable through the
13