Raket 95 Owner's Manual - page 13
www.raketengines.com
Raket 95 Manual - English
13
and screw in the High Speed screw too
much, because then the engine will not
receive enough fuel and as a result not
enough oil, which can lead to piston and
cylinder damage. The High Speed screw
should always remain opened at least a
0,75 turn.
7.
When you have found exactly the right
setting for the High Speed screw you
should check the settings of the Low
Speed screw and the idling adjustment
screw again. You can feel satisfied when:
- the engine idles easily without pulling
the kart, and you hear the occasional
pinging sound from the clutch but not so
often.
- the engine responds directly when
you apply the gas, both when idling and
when you are driving on the track and, for
instance, have taken your foot off the gas
going into a curve and then apply the gas
again.
- the engine winds up properly on the
track’s straight sections, but begins to
splutter at the very end of the longest
straight.
8.
If you find after having driven for a while
that you are no longer able to achieve a
correct setup then it may be time to clean
the carburettor. See the section about ser-
vicing the engine.