RAMSET D45A Operator's Safety & Operating Instruction Manual - Tool Operating Instructions
4. Close the cover and be sure it is locked.
NEVER attempt to make a fastening with
the tool cover in the open or unlocked
position.
5. Hold the tool perpendicular (90°) to
the work surface with both hands and
press firmly to fully depress the tool.
Maintain firm downward pressure on
the tool with both hands and pull the
trigger to drive the fastener.
DO NOT
DEPRESS THE TOOL AGAINST
ANYTHING OTHER THAN THE
INTENDED WORK SURFACE. Holding
the tool firmly in place will produce
more consistent fastening quality and
minimize tool wear or damage.
6. After making the fastening, let up on
the tool pressure and note that the
barrel assembly returns to the full open
position. This automatically resets the
piston for the next fastening.
Always
keep fingers and other body parts
away from the muzzle end of the
tool.
7. Insert another fastener in the muzzle
end of the tool as before and the tool
is ready for the next fastening. Keep
your finger off of the trigger until the
tool is in position to drive the fastener.
8. To remove a used or partially used
load disc from the tool, open the
cover and lift out the load disc.
NEVER try to remove a jammed or
stuck load disc. Should a “jammed”
load disc occur, call your local
Authorized Ramset Distributor for
technical assistance.
SHOULD YOU DECIDE NOT TO MAKE A
FASTENING AFTER THE TOOL HAS BEEN
LOADED, ALWAYS REMOVE THE POWDER
LOAD FIRST, THEN THE FASTENER. THIS
WILL PREVENT ACCIDENTAL DISCHARGING
OF THE FASTENER OR PISTON INTO THE
OPERATORS HAND.
TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
10
HOLD THE TOOL FIRMLY AND
PERPENDICULAR TO THE WORK SURFACE
INSERT THE NEXT FASTENER
REMOVE THE LOAD DISC
LET UP ON TOOL PRESSURE.
NOTE THE BARREL HAS RETURNED
TO THE OPEN POSITION
90°