RAMSET D45A Operator's Safety & Operating Instruction Manual - Tool Operating Instructions
TOOL OPERATION
DAILY FUNCTION TEST
Always check the tool first to make sure
that it does not contain a disc load or
fastener. Test the tool several times by
depressing the muzzle bushing fully on a
hard surface and pulling the trigger. You
should hear an audible click as the firing
pin releases. Let up on the tool and check
to be sure the barrel has opened to the
semi-closed position.
OPERATING THE D45A TOOL
1. After checking to be sure that the tool
is not loaded, point it in a safe direction
and be sure that the barrel is fully
extended. This assures that the piston
is in position for the next fastening. Use
the spall guard every time possible to
minimize the risk of being struck by
flying debris.
2. With finger off the trigger, place the
fastener, point out, into the muzzle end
of the tool until the point end is inside
the muzzle.
NEVER load a fastener
with your finger on the trigger.
DO NOT
use excessive force when inserting a
fastener.
STOP immediately if excessive
force is required, inspect the barrel to
find out why the fastener is not entering
the muzzle freely.
DO NOT continue
loading unless the problem is corrected.
3. With the tool pointed in a safe direction
and finger away from the trigger, open
the cover by pressing the side button,
and insert a load disc into the slots in
the receiver housing.
TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
9
PERFORM FUNCTION TEST WITH
EMPTY, UNLOADED TOOL
BE SURE THE BARREL IS
FULLY FORWARD
INSERT FASTENER INTO THE
MUZZLE END OF THE TOOL WITH
THE POINT OUT
INSERT LOAD DISC INTO THE
SLOTS IN THE RECEIVER HOUSING