RAMSET D45A Operator's Safety & Operating Instruction Manual - Disassembly
DISASSEMBLY
14
DISASSEMBLY
TOOL DISASSEMBLY
1. Uscrew the barrel retention collar and
slide it away from the tool housing.
Handle the tool carefully after the
sleeve is unscrewed to prevent the
two barrel pawls from falling out.
2. Remove the two pawls from the slots
in the sides of the tool housing.
3. Slide the barrel asembly out of the tool
body. Note the position of the slots on
the side of the barrel assembly.
4. Slide the barrel retention collar off of
the barrel assembly.
5. Using an adjustable or 13mm open
end wrench, grip the flats on the end
of the muzzle bushing and unscrew
the muzzle bushing from the barrel
assembly.
UNSCREW THE BARREL
RETENTION COLLAR
REMOVE BOTH PAWLS
SLIDE RETENTION COLLAR AND
RETURN SPRING OFF OF THE BARREL
UNSCREW MUZZLE BUSHING
FROM BARREL ASSEMBLY
SLIDE BARREL ASSEMBLY
OUT OF THE TOOL BODY
Pawl location