RAMSET D60 Operator's Safety & Operating Instruction Manual - Troubleshooting
REFER TO PARTS SCHEMATIC FOR PROPER ASSEMBLY OF PARTS
– Overdriving of fasteners
– Excessive power
– Change to the next lower
power level load disc
color and number.
– Soft base material
– Check base material
(see page 3)
– Tool fails to fire
– Failure to depress
– See “Tool does not
completely
completely depress”
– Excessive dirt buildup on – After following misfire
breech face not allowing procedure, check firing
proper penetration of
pin indentation on load.
firing pin
Clean breech face
– Firing pin and/or breech
– Replace damaged parts
damaged
– Tool does not completely – Misassembled or
– Check all parts in the
depress
damaged parts
receiver for damage or
improper assembly.
– Reduction or loss of power – Piston not being returned – Barrel must be pulled
to the full rear position
completely opened to
properly reset the piston.
– Worn or damaged
– Replace worn or
piston or piston ring
damaged parts
– Worn or broken pawls
– Replace pawl
– Tool cannot be cocked
– Excessive dirt buildup
– Clean tool thoroughly
or opened
– Damaged or bent piston
– Replace piston
– Broken or damaged parts – Tag tool with warning
“Defective–Do Not Use”
Place in a locked container
and contact your local
Ramset representative
for service.
– Failure to index load
– Disc not inserted in tool
– Check load disc. Properly
correctly or is damaged
dispose of damaged disc.
(See page 6)
– Damaged indexing
– Contact your Ramset
mechanism
Distributor for assistance.
– Failure of tool to stay
– Retaining ball missing
– Contact your Ramset
closed when pointed
Distributor for assistance.
downward
TROUBLESHOOTING
TROUBLESHOOTING
13