RAMSET D60 Operator's Safety & Operating Instruction Manual - page 9
TOOL OPERATION
Daily Function Test
Always check the tool first to make sure
that it does not contain a disc load or
fastener. Test the tool several times by
depressing the muzzle bushing fully on a
hard surface and pulling the trigger. You
should hear an audible click as the firing
pin releases. Let up on the tool and check
to be sure the barrel has opened to the
semi-closed position.
OPERATING THE D60 TOOL
1. After checking to be sure that the
tool is not loaded, point it in a safe
direction and be sure that the barrel
is fully extended. This assures that
the piston is in position for the next
fastening. Use the spall guard every
time possible to minimize the risk of
being struck by flying debris.
2. Slide the barrel to the semi-closed
position.
NEVER place your hand,
fingers or any other part of your
body over the muzzle (fastener
loading end) of the tool.
3. With finger off the trigger, place the
fastener, point out, into the muzzle
end of the tool until the point end is
inside the muzzle.
NEVER load a
fastener with your finger on the trigger.
DO NOT use excessive force when
inserting a fastener.
STOP immediately
if excessive force is required, inspect
the barrel to find out why the fastener
is not entering the muzzle freely.
DO
NOT continue loading unless the
problem is corrected.
TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
9
PERFORM FUNCTION TEST WITH
EMPTY, UNLOADED TOOL
OPEN BARREL TO THE
FULL OPEN POSITION
CLOSE BARREL TO THE
SEMI-CLOSED POSITION
INSERT FASTENER INTO THE
MUZZLE END OF THE TOOL
WITH THE POINT OUT
Keep hand away
from muzzle.