RAMSET D60 Operator's Safety & Operating Instruction Manual - Disassembly
DISASSEMBLY
16
DISASSEMBLY
TOOL DISASSEMBLY
1. Slide the barrel assembly out of the
tool until the barrel shroud clip is
exposed.
2. Unscrew and remove the pawl
assembly. Note the position of the
notch on the pawl as the pawl is
removed. The pawl must be installed
at reassembly with the notch in this
direction.
3. Slide the barrel assembly completely
out of the tool body. Note the position
of the ball bearing retainer with the slot
in the top of the receiver for reassembly.
4. Remove the barrel shroud clip using a
flat screwdriver or long fastener. Take
care when removing to be sure the clip
does not fly away when freed from the
outer barrel.
SLIDE THE BARREL ASSEMBLY OUT OF
THE TOOL TO EXPOSE THE CLIP
REMOVE THE PAWL ASSEMBLY
REMOVE THE BARREL SHROUD CLIP
SLIDE THE BARREL ASSEMBLY OUT OF
THE TOOL BODY
Shroud Clip
Notch