Range Senator RFB006 6kW Installation And User Instructions Manual - page 2
INTRODUCTION
Introduction
2
Installer Detail
2
Description
3
Features
3
Models
3
Warranty
3
Basic Components Diagram
4
Basic Installation Dimensions
5
Operation and Indicators
6
Cleaning
6
Installation
6
Fitting
6
Plumbing / Heating installation
6
Basic Plumbing Layout
9
3 Boiler Plumbing Schematic
11
Wiring Instructions
12
Electrical Connections
12
Set up and test
14
Initial set up procedure
14
Main Test procedure
14
Parts location
15
Servicing
15
Fault Finding
15
Fault Reset Procedure
15
Fault Tracing chart one
16
Fault Tracing chart two
17
Fault Tracing chart three
18
Replacing the Main Powerboard
19
Powerboard Connections
20
Control Diagram
21
6 kW Boiler Wiring Diagram
22
9 kW Boiler Wiring Diagram
23
11 & 12 kW Boiler Wiring Diagram
24
Technical Specification
25
Heating Only Wiring Diagram
26
Typical Y Plan Wiring Diagram
27
Typical S Plan Wiring Diagram
27
Parts Listing
28
Limitations on Electrical Supply
29
Multiple Boiler Relay
30
2
Name:
Address:
Tel. No:
Date of installation:
Inhibitor used:
Model:
Serial Number:
CONTENTS
Every effort has been made to ensure the information contained in this manual is correct at the time of going to press, however Kingspan reserves
the right to change any information herein without notice. Senator is a Trademark of Kingspan Plc.
Range Senator
RFB 006
RFB 009
RFB 011
RFB 012
Your Electric Flow Boiler has been developed to provide many years of trouble free service when installed and maintained correctly. Every effort has
been taken to ensure the highest standards of reliability and safety from your purchase, however in the event of a suspected fault never attempt to
repair the boiler yourself. Consult your local installer as detailed below.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use of the appliance by a competent person responsible for their safety.
Notes for the installer.
This document is specifically written for the Electric Flow Boiler. This manual must be read and explained to the householder by the installer and
left with the householder after installation. All boilers are packed in cardboard cartons. Inspect the boiler before installation. Any damage must be
reported to the supplier in writing within seven working days.
Installed by:
These instructions are applicable to the following models of electric flow boiler: