Rangemaster Classic 90 Gas User Manual - page 21
21
If more than one shelf is used, check that
space has been left for the heat to circulate.
When a baking tray is put into the oven, make
sure it is placed centrally on the shelf.
Check that the door seal is not damaged and
that the door catch is adjusted so that the
door is held fi rmly against the seal.
A dish of water when placed on the shelf
should be the same depth all over. (For
example, if it is deeper at the back, then the
back of the cooker should be raised up or
the front lowered). If the cooker is not level
arrange for your supplier to level it for you.
Oven not coming on when turned on manually
Is the power on? Is the clock illuminated? If
not there may be something wrong with the
power supply. Is the cooker supply on at the
isolator switch? Is the clock fl ashing 0.00?
If so set it to the correct time of day. Has
the Timer been set to AUTO by mistake. If
AUTO is showing on the clock display, press
the ‘cook period’ button and reduce any set
cooking time showing to 0.00, with the (+)
and (-) buttons. Press the button twice.
Is the key symbol ( ) showing in the display?
See the Clock section of the instructions for
more information on the key lock feature of
the clock.
Oven not coming on when automatic cooking
Timer set correctly but oven knob left OFF by
mistake?
Is the key symbol ( ) showing in the display?
See the Clock section of the instructions for
more information on the key lock feature of
the clock.
Oven temperature getting hotter as the cooker
gets older
If turning the knob down has not worked or
only worked for a short time then you may
need a new thermostat. This should be fi tted
by a service person.
The Main oven light is not working
The bulb has probably blown. You can buy a
replacement bulb (which is not covered under
the guarantee) from a good electrical shop.
Ask for an Edison screw fi tting 15w 230v
lamp, FOR OVENS. It must be a special bulb,
heat resistant to 300 °C.
Open the oven door and remove the
Handyrack (if fi tted) and oven shelves.
Turn off the power supply.
Unscrew the bulb cover by turning
anticlockwise. Unscrew the old bulb. Screw in
the new bulb, screw back the bulb cover. Turn
on the electricity supply and check that the
bulb now lights.
Current Operated Earth Leakage Breakers
Where the cooker installation is protected
by a 30 milliamp sensitivity residual current
device (RCD), the combined use of your
cooker and other domestic appliances may
occasionally cause nuisance tripping. In
these instances the cooker circuit may need
to be protected by fi tting 100mA device. This
work should be carried out by a qualifi ed
electrician.
Power failure
In the event of a failure in the electrical supply
the hotplate may be lit using a match.
If there is an installation problem and I don’t get
my original installer to come back to fi x it who
pays?
You do. Service organisations will charge
for their call outs if they are correcting work
carried out by your original installer. It’s in
your interest to track down your original
installer.
What cleaning materials are recommended for
the cooker?
See the ‘Cleaning your cooker’ section for
recommended cleaning materials. We do
not recommend Mr. Muscle, as it contains
chemicals that may damage the surfaces of
your cooker.