Rangemaster Toledo 110 Dual Fuel Users Manual & Installation - page 27
27
WARNING SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
1
To Remove the Control Panel
Disconnect from electricity supply.
Pull off all the control knobs.
Open the grill and right hand oven doors and remove
the 4 fi xing screws underneath the control panel.
The control panel should drop down slightly. It is held at
the top by two holes in the top edge, one at each end,
that locate on tags on the inner panel.
Clear the control panel holes from the inner panel and
pull the control panel forward.
Disconnect the wiring from the rear.
Reassemble in reverse order. When replacing leads refer
to the wiring diagram. Check operation of timer.
2. To Remove Hotplate
Disconnect from electricity supply.
Remove the pan supports and burner heads. Remove
the screws holding the hotplate burners to the hotplate.
Remove the 4 screws holding the hotplate tray to the
cooker.
Taking care not to damage the burner electrodes,
carefully lift the hotplate, from underneath disconnect
the earth lead at the right hand rear from the rear cross
member and withdraw the hotplate.
Reassemble in reverse order ensuring that the leads
are reconnected. Take care not to damage the ignition
electrodes of the burners.
It is important that the rear earthing leads are replaced
when the fi xing screws are refi tted as they from part of
the cooker earthing.
Check for correct burner operation.
Servicing
BEFORE SERVICING ANY GAS CARRYING COMPONENTS.
TURN OFF THE GAS SUPPLY
Check the appliance is gas sound after completion of
service. When checking for gas leaks do not use washing
up liquid - this can corrode. Use a product specifi cally
manufactured for leak detection.
Do not use re-conditioned or unauthorised gas controls.
Disconnect from the electricity supply before
commencing servicing, particularly before removing any
of the following: - control panel, side panels, hotplate
tray or any electrical components or covers.
Before electrical re-connection, check that the appliance
is electrically safe.
Note - References to LH and RH oven apply as viewed
from the front.
Contents
1 To Remove the Control Panel
27
2. To Remove Hotplate
27
3. To Remove Side Panels
28
4. To Remove Ignition or light Switch
28
5. To Remove Clock
28
6. To Remove a Thermostat
28
7. To Change Grill Controller
28
8. To Change Control Taps
28
9. To Change Hotplate Burner Injector
28
10. To Change Hotplate Burner Electrode
28
11. To Remove or Change a Hotplate Burner.
28
12. To Remove an Oven Door
29
13. To Change Oven Door Outer Panel
29
14. To Change Oven Door Latch
29
15. To Adjust an Oven Door Catch Keep
29
16. To Change Oven Door Seal
29
17. To Remove Grill Element.
29
18. To Remove RH Oven Inner Back.
29
19. To Change Fan in RH Oven.
30
20 To Remove an Oven element Thermal Cut-Out.
30
21. To Remove RH Oven Element.
30
22. To Remove the LH Oven Bottom and Top Elements
30
23. To change oven light bulb.
30