Rath Command Center Installation & Operation Manual - Items Included
Items Included
1. For wall mount units, install cabinet in desired location. For desk mount, install stand (included) on back
of unit.
2. Mount the Distribution Module and Power Supply with battery backup in an approved location.
3. Take one end of the Distribution Module Power Cable and plug it into the DC Adapter Port on the
Distribution Module and the other end into the Rath model RP7700104 (12-36 Zone) or model
RP7701500 (56-92 Zone) Power Supply with battery backup.
4. If 12-36 Zone, remove screws on the back of the unit and take cover off to expose internal ports.
5. Connecting Command Center to Distribution Module:
a. The Command Center connects to Card 1 of the Distribution Module (see pages 6-7).
Note: The maximum cable length to Command Center is 6200’ for 22 GA cable and 3900’ for 24 GA cable.
b. If Command Center includes auxiliary Button Console or Secondary Station, connect to the
Distribution Module per the following:
i. Button Console 1 or Secondary Station (12-16 Zone): (See pages 6-7).
ii. Button Console 2 and/or a Secondary Station (28-92 Zone) with Button Consoles(s):
Locate additional DKP port(s) on additional card and wire out with appropriate pair for
extension on port.
6. Connecting Emergency Phones to Distribution Module:
a. Emergency Phones connect to the Distribution Module via the included wiring harnesses.
b. Plug the RJ45 connectors of the wiring harness into the ports of the Module following the
diagrams on pages 6-7.
c. Wire the locations to single pair 22 or 24 gauge twisted-shilded cable following EIA/TIA Standards.
d. Connect the cabling to the Distribution Module.
Note: The maximum cable length to Emergency Phones is 112,500’ for 22 GA cable and 70,300’ for
24 GA cable.
7. Turn on the Power Supply.
8. Power on Distribution Module.
Page 2
N56W24720 N. Corporate Circle Sussex, WI 53089
800-451-1460 262-246-4828 (fax)
www.rathmicrotech.com www.area-of-refuge.com
Installation
• Base Station
• Distribution Module
• Wiring Harnesses
Distribution Module Programming
Note: All Distribution Module programming will be done from the Command Center handset.
Programming Time Zone
1. Enter Programming Mode:
a. Dial
1#91
b. Enter Password:
7284