Rath Command Center Installation & Operation Manual - Operating Instructions
Page 4
Connect the Phone to an active Port on Distribution Module and follow the instructions below:
Emergency Phone Location Message (Optional Feature):
If you require a “Location Message”, set-up as follows:
2100 Series: Set message frequency to option “3”. Record your message. At the end of the message,
add, “For two-way communication, press * at any time”.
2400 Series: Set message frequency to “3”. Record your message. At the end of the message, add:
“For two-way communication, press # after the beep”.
At Command Center:
1. Press 1#91 (enters system admin mode)
2. Press 7284 (system admin password)
3. Press 25011, Check Mark Button (enters message programming)
4. Press 250201, Check Mark Button, wait 5 seconds, press Check Mark Button again (records dead
air in place of emergency message on Distribution Module)
5. Press 00, Check Mark Button
Note: The silence is to avoid message conflicts. If sound is recorded it will be heard along with locally
recorded message.
Operating Instructions
Indicator Status:
1. Red LED Light– Incoming Call or Connected to Outside Party
2. Blue LED Light– Active Call
3. Blue LED Flashing– Call on Hold
Answering Call at Command Center:
1. Lift handset to answer first incoming call
2. If multiple calls, press red LED light of next desired call (this will place the original call on hold)
Disconnecting Calls:
1. Select the desired flashing blue LED and press the *, # buttons
2. Each call must be disconnected individually
Note: If you hang up handset before disconnecting each call, LED(s) will remain lit. Lift handset, press lit
LED, 5, then
*, #. To disconnect, hang up handset. Repeat for each lit LED.
Calling a Location:
1. Pick up handset and press desired location key (blue LED will light)
Joining an Existing Conversation between Location and Outside Party:
1. Pick up handset, press red LED, then 5 button
2. You will be in a 3 way conversation with the outside party and location
Call the Last Phone that Dialed Out:
1. Pick up the handset and dial 1092