Ravelli Pompeii Owners & Installation Manual - page 31
29
Manuale utente PALMARE IDRO TOUCH RADIO
Manuale utente PALMARE IDRO TOUCH RADIO
Pag.38
Pag.39
Vers. 01 del 07/04/15
Vers. 01 del 07/04/15
In the case of alarm 07 THERMAL BREAKER below shows the location
where to operate to reset the thermal switch with manual reset.
Svitare il tappo di protezione e premere
il pulsante per riarmare il termico
Termico a riarmo manuale
Before any cleaning operation on the stove, implement the following precautions:
- switch off the stove and disconnect the power cord with the stove in “SWITCHED OFF” state;
- make sure all the parts of the stove are cold;
- make sure the ash is completely cooled.
To clean the surfaces of the coated metal parts, use a cloth soaked in water or water and soap.
Use of abrasive detergents or diluents can damage the surface of the stove.
SI PREGA DI SEGUIRE ATTENTAMENTE LE SEGUENTI ISTRUZIONI PER UNA CORRETTA PULIZIA.
LA NON ADEMPIENZA POTREBBE CAUSARE MALFUNZIONAMENTI ALLA Termostufa.
Cleaning should be provided by the user
Pull out the drawer from the stove and remove the ash using a special vacuum cleaner; be very careful to the brazier that may still be
hot that may damage the equipment used for cleaning.
Cleaning the ash pan
Cleaning operations of the stove depend on the quality of the pellets used and the frequency of use.
It may be necessary to carry out these operations on a daily basis.
EACH ALARM CAUSES THE IMMEDIATE SWITCHING OFF OF THE STOVE. PRESS THE SWITCH-ON BUTTON
TO RESET THE ALARM. BEFORE SWITCHING ON THE STOVE, MAKE SURE THE SIGNAL HAS BEEN REMOVED
AND (UNLIKE MODELS EQUIPPED WITH AUTOMATIC CLEANER) THAT THE BRAZIER IS PROPERLY CLEANED TO
ENSURE CORRECT RESTART.
Ash pan that needs
to be emptied
Drawer
ash
Th
e glass of the door should be cleaned with the stove cooled down using a cotton cloth or paper towel.
Usually, we recommend you clean the glass with a damp (water) cloth and ash collected after burning (having an abrasive function).
NO PONGA EN MARCHA la Termoestufa YA QUE PODRÍAN PRODUCIRSE DAÑOS EN EL VIDRIO.
CONTACTE AL SERVICIO DE ASISTENCIA PARA SUSTITUIRLO.
Operate the up/down pins to keep the tube bundle clean and ensure the best water heat
exchange in the stove.
Cleaning glass
Manual tube bundle cleaning(where applicable)
Pins to be operated
“Up/Down”
This is a manual containing general information. Therefore, all assembly/disassebly and cleaning operations of the
stove are given in the dedicated manual of the stove, together with the following general manual.
PARTS / FREQUENCY
1 DAY
2-3 DAYS
30 DAYS
60-90 DAYS
1 SEASON
Brasero*
•
Ash pan
•
Glass
•
Suction duct**
•
Door gasket**
•
Turbulators
•
Flue*
•
Combustion chamber
•
Vacuum pellet tank
•
Electrical-mechanical parts
**
•
Below are summarised the checks and/or maintenance interventions required for the proper operation of the stove.
* Only for models that are not equipped with automatic cleaner;
* * Operations to be carried out by authorized technical staff.
Warranty conditions
The warranty covers manufacturing material defects, provided the product was not subject to breakages caused by improper
use, negligence, incorrect connection, tampering or installation errors.
Not covered by the warranty:
- vermiculite (firex 600)
- the door glass;
- the fibre seals;
- the paint;
- the combustion basket in stainless steel or cast iron;
- the resistor;
- the coloured majolica;
- any damage due to inadequate installation and/or tampering with the stove and/or negligence on the customer’s part.
Use of poor quality pellets or any other material which could damage the components of the stove cause the warranty to become invalid,
as well as the relevant liability of the manufacturer.
Therefore, we recommend you use pellets that meet the requirements in the specific chapter.
All damages caused by transport are not recognised, therefore we recommend you carefully check the goods on receipt,
immediately advising the dealer of any damage.
The warranty form must be detached and sent within 8 days of purchase to the following address:
Ravelli srl
Via Kupfer, 31
25036 Palazzolo s/O
Brescia (ITALIA)
Info and problems
For any information or support request, please contact your dealer or support centre because our staff is able to meet your every need
and intervene directly, if necessary.
Warranty
Warranty Certificate
Ravelli srl would like to thank you for purchasing one of our pellet stoves and invites you to:
- read the instructions for installation, use and maintenance of the stove.
- note the warranty conditions reported below.
The warranty form annexed must be compiled and stamped by the installer to activate the warranty.
Otherwise the warranty shall not enter into effect.