Raychem h910 Installation Instructions Manual - page 2
1
Identify heating cable
2
Installation Instructions
H910 Splice and Tee Kit
2
For all heating cables
3a
For H612 and H622 heating cables only
3b
For H311, H611, and H621 heating cables only
WinterGard H311, H611, H621
Heating cables with braid
but no outer jacket
WinterGard H612, H622
Heating cables with both
braid and outer jacket
Note: Illustrations generally show a heating cable with both braid and an outer jacket.
Cables with no outer jacket will look slightly different.
• Allow 12 inches of extra
heating cable as shown.
If necessary, trim cables
evenly.
• Lightly score completely around
and then down outer jacket
2 inches from end.
• Bend heating cable to break
jacket at score, then peel off
outer jacket.
• Push braid back.
• Gently spread apart
braid as shown.
Note: Illustrations of the following
instructions all show a tee connection.
Perform splice connections the same
way but use only two heating cable
sections, not three as shown.
H612, H622
H311, H611, H621