Raychem h910 Installation Instructions Manual - page 5
5
Installation Instructions
H910 Splice and Tee Kit
12
For H612 and H622 heating cables only
13
For all heating cables
14
For all heating cables
15a
For H612 and H622 heating cables only
15b
For H311, H611, and H621 heating cables only
• Fold the crimped braid back against the
heating cables.
• Wrap black cloth tape evenly around crimp
and heating cables. Cover crimp completely.
• Select one bus wire
from each cable
section and twist the
wires together.
• Position one 6-inch-
long heat-shrinkable
tube as shown.
• Measure 4 1/2 inches from end of
cap and mark cable. Position the
6-inch-long heat-shrinkable tube
as shown.
• Slide heat-shrinkable cap
over bus wire crimps.
• It is not necessary to shrink cap.
• Use insulated bus
wire crimps and T&B
crimp tool to crimp
each set of bus wires
together.
• Repeat with
remaining bus
wires.
Note:
Be careful
not to
twist
together
bus wires from the
same heating cable.