Raymarine Base Station Installation And Commissioning Manual - Important Information

Other manuals for Base Station: Operation Manual, Installation Manual
Manual is about: Raymarine Base Station Base Station & Wireless Controller: Install Guide

Summary of Base Station

  • Page 1

    Lifetag system installation & commissioning guide document reference: 87064-3 date: july 2006 87064_3.Book page 1 friday, july 28, 2006 9:32 am.

  • Page 2

    Raymarine and seatalk are trademarks of raymarine plc © handbook contents copyright raymarine plc 87064_3.Book page 2 friday, july 28, 2006 9:32 am.

  • Page 3: Important Information

    Lifetag system installation & commissioning guide i important information warnings: lifetag system 1. The raymarine lifetag system is an auxiliary safety system, intended only to provide additional protection to the vessel's crew. Do not rely solely on this system for crew safety; do ensure that all...

  • Page 4

    Ii lifetag system installation & commissioning guide 87064_3.Book page ii friday, july 28, 2006 9:32 am.

  • Page 5: Getting Started

    Lifetag installation & commissioning guide 1 lifetag installation & commissioning guide getting started figure 1 - parts supplied figure 2 - tools required figure 3 - locating base station no. 6 self-tapping screws x2 base station straps x2 strap extensions x2 tags x2 cable ties buzzer, bracket and ...

  • Page 6: Emc Installation Guidelines

    2 lifetag installation & commissioning guide figure 4 - base station separations emc installation guidelines raymarine equipment and accessories are designed to the best industry standards for use in the recreational marine environment. Their design and manufacture conforms to the appropriate electr...

  • Page 7: Connecting Base Station

    Lifetag installation & commissioning guide 3 connecting base station the lifetag system base station has to be connected to a 12 v dc power source and to the alarm buzzer: • temporary connections are required to enable an initial site survey to be carried out. • permanent connections are required wh...

  • Page 8

    4 lifetag installation & commissioning guide connecting base station when seatalk available figure 6 - base station connection to seatalk compatibility with other seatalk products if the lifetag base station is connected to a seatalk system which includes a seatalk chartplotter and gps, and a lifeta...

  • Page 9: Connect Alarm Buzzer

    Lifetag installation & commissioning guide 5 connect alarm buzzer figure 8 - alarm buzzer connections connect switched 12 v output (optional) the switched 12 v output can be used to automatically trigger appropriate emergency systems, when a mob event occurs. Figure 9 - optional 12 v output connecti...

  • Page 10: Fit Tag Battery

    6 lifetag installation & commissioning guide fit tag battery before you can use the tags, you must fit a battery in each, as in figure 10 . Figure 10 - fitting tag battery ensure satisfactory lifetag coverage the nominal lifetag base station-to-tag range is 30 feet (9 meters), so on boats where this...

  • Page 11

    Lifetag installation & commissioning guide 7 5. Take the tag to every part of the vessel to which crew members have access, (i.E. Every cabin, com- partment and all extremes of the deck), to check if an alarm is initiated. If any alarms occur, the system is not operating satisfactorily. 6. Take the ...

  • Page 12

    8 lifetag installation & commissioning guide figure 11 - setting a base unit as a repeater 4. Ensure that the 12 v dc supply is switched off, then connect both base stations, via a switch and 5 a fuse, to the supply as in figure 12 . Do not connect the yellow wire to the repeater. Figure 12 - power ...

  • Page 13

    Lifetag installation & commissioning guide 9 installing a master/repeater system to install a master/repeater base station system, refer to figure 13 and: 1. Position the master and repeater base stations to give optimum coverage on the boat (for exam- ple, one forward and one aft). Figure 13 - usin...

  • Page 14: Fitting Procedures

    10 lifetag installation & commissioning guide fitting procedures when you are satisfied that your lifetag system will give satisfactory coverage aboard your boat: • fit the base station and alarm buzzer, as described in figure 14 and figure 15 respectively, then connect up your system. A summary of ...

  • Page 15: Fitting Alarm Buzzer

    Lifetag installation & commissioning guide 11 fitting alarm buzzer figure 15 - fitting buzzer connecting system important: when connecting any part of the system, refer to the appropriate diagrams under connecting base station (above) to ensure you connect correctly when you have secured the base st...

  • Page 16: Commissioning

    12 lifetag installation & commissioning guide commissioning important before attempting to use any tag, ensure the led indicator on the tag is flashing green, to show the tag is registered with your base station. If a tag indicator is not flashing green, de-register the tag is as described on page 1...

  • Page 17: Registering A Tag

    Lifetag installation & commissioning guide 13 ii. Wait 15 seconds, then hold down the tag button for a further 5 seconds. Note: you can cancel an alarm from any active tag within range of the base station. Tag registration & de-registration registering a tag tags supplied with a base station as part...

  • Page 18: De-Registering A Tag

    14 lifetag installation & commissioning guide de-registering a tag if you want to de-register a tag (for example, to use it with a different base station): 1. De-activate the tag by switching off the associated base station then waiting for at least one minute. When the tag is inactive, the indicato...

  • Page 19: Specification

    Lifetag installation & commissioning guide 15 specification fcc and industry canada information the lifetag and lifetag base station comply with us cfr47 part 15 rules and with ic standard rss210. Operation is subject to the following two conditions: (1) these devices may not cause harmful interfere...

  • Page 20

    16 lifetag installation & commissioning guide raymarine uk ltd, quay point, northarbour road portsmouth, hampshire po6 3td, united kingdom. Tel: +44 (0) 23 9269 3611 fax: +44 (0) 23 9269 4642 www.Raymarine.Com raymarine inc, 21 manchester street, merrimack, new hampshire 03054, usa. Tel: +1 603.881....