RIVATECH RC 8102HD Quick Start Manual - page 3
RC810212-2014-A
3
3. Install the main unit
1) Pull out both slide plates at the bottom of the main unit.
2) Place the main unit on the installation surface by facing the bottom of the main unit toward the
installation surface, and mark the drilling spots based on the alignment holes on the slide plates.
3) Drill the marked spots, and insert the anchor blocks to the drilled holes. Then, fix the main unit by
inserting the tapping screws to be passed through the alignment holes on the main unit and tightening
them into the anchor block.
4. Connect cables
1) Connect external input/output devices (e.g. alarm device) optionally if they are necessary. Refer to the
section of DI/DO terminal connector in the installation guide for more details.
2) Connect the camera unit to the main unit by inserting the camera’s DIN connector to the camera’s
connector on the main unit like Figure 1.
3) Connect the main unit to the network using an Ethernet cable (RJ45). Then, install the ferrite core on the
Ethernet cable like Figure 2.
4) Connect a DC12V power adaptor to the power connector on the main unit.
Note
i
Please make sure that the camera unit needs to be connected to the main unit prior to the
power connection. Otherwise, the camera may fail to show image.
C
Out C
In
DO
DI
DO
DO
Slide plate
M4x25
tapping screw