RIVATECH RC 8102HD Quick Start Manual - page 6
RC810212-2014-A
6
To set up the Network configuration:
1. Click Setup on the upper right of the web page. The login page is displayed as below.
2. Enter the default user name (root) and password (pass), and then select OK.
3. Click System Options on the left of the Setup page, and then select TCP/IP from the drop-down menu.
4. Input the data for the IP address configuration, and click the Apply button on the bottom of the page.
When modifying the IP address, be advised to have the correct Subnet mask and Gateway ready. To use DHCP,
select Obtain an IP address via DHCP.
More Information
To learn more about using other features of your devices, refer to the manuals as “RIVA Web Interface Manual
Full HD Series” or “VCAsys User Manual (Online Help)”, which is available on
www.rivatech.de
homepage.
7. Reboot
Perform the following procedures to reset your device:
1. Press the Reset button, and hold it for 2 seconds while the device is in use.
2. Wait for the system to reboot.
Caution
!
Please do not hold the reset button for more than 2 seconds. Otherwise, the
camera may be switched to its Factory Default settings.
8. Factory Default
Resetting the device back to the factory default will initialize all parameters including the IP address back to
the factory defaults. To reset back to the factory default:
1. Press the rest button and hold it while the device is in use.
2. Release the button after about 10seconds.
3. Wait for the system to reboot.
The default username
and password are:
root
and
pass
.