RIVATECH RC 8102HD Quick Start Manual - page 7
RC810212-2014-A
7
Note
i
The factory default settings can be inferred as follows:
IP address:
192.168.xx.yy
Network mask:
255.255.0.0
Gateway:
192.168.0.1
User ID:
root
Password:
pass
9. Safe Mode
Your device will get restarted with safe mode when the device does not completely boot certain times.
The errors are mainly caused by these two factors: power source unplugged or damage occurred on
firmware file during the system boot.
The messages like below will appear on the webpage when your device has been rebooted in ‘safe mode’.
Then, you should follow the instructions on the webpage according to the steps in a row.
Note
i
There is another method to update firmware, which is using IPAdminTool.
Please refer to ‘IPAdminTool User’s Manual.pdf’ for the detailed procedure.
Note
i
If your device is still at safe mode after trying to update firmware,
please contact your local agency to get further assistance.