RMS Gill 2 Installation And User Manual - page 13
BACKREST ANGLE ADJUSTMENT (cont)
Method (2) - is where the Locating
Clamps for the front Seat Hook Brackets
are already fitted towards the front end of
wheelchair Seat Rails, just clear of the
Parking Brake Mounts and front Seat
Rail Saddles and therefore unable to be
moved forwards. Fig.7c.
NOTE: The Gill 2 Seat Unit must be
vacated for this adjustment.
Tools Required:
4mm Hexagon Key and 10mm Spanner.
1. Remove Gill 2 from wheelchair and remove Seat Cushion.
2. Remove nuts and screws from both front Pelvic Support Brackets and remove
the Seat Depth Adjustment Panel, refer to Figs.5 & 6.
3. Disconnect and remove each front Seat Hook Bracket and relocate to either one
or two holes rearwards on the Seat Panel, see page 7.
NOTE: Moving the Hook Brackets rearwards by one hole will change the Backrest
angle to 95º whereas moving two holes will achieve the 100º angle. Fig.7a.
4. Ensure both Hook Brackets are level across the Seat and retighten the domed
securing nuts, sufficient to prevent any movement.
5. Re-install Seat Depth Adjustment Panel, set to the required depth and secure,
ensuring Pelvic Supports are also set to the required width.
6. Re-install Gill 2 Seat Unit, as described on page 8 (4-5), ensuring the Seat
Hook Brackets are located correctly over the Seat Rails.
7. Reconnect both Backrest Retaining Straps and re-tension as required, using the
pull-
tight “D” Rings Fig.4, page 9.
8. Refit Seat Cushion.
13
Seat Hook
Bracket
Fig.7c