RMS Gill 2 Installation And User Manual - Pelvic Support Adjustments
PELVIC SUPPORT ADJUSTMENTS
IMPORTANT
NOTE:
Unless
specific
dimensions have been requested with the
original order, the Pelvic Supports will be
set to an average position and may not be
fully
tightened.
Therefore,
correct
positioning and security will be necessary.
The Gill 2 full-length Pelvic Supports are
individually adjustable by 55mm each side. The
minimum and maximum Pelvic Widths for each
of the Gill 2 seat sizes are stated in the
Technical Information section on page 4.
Tools Required: 10mm Spanner
To adjust Pelvic Support Width:-
1. Slacken the two M6 domed Nylock Nuts
Fig.8a, on each side, sufficient to allow the
Pelvic Support to be moved inwards or
outwards to the required position.
2. Re-secure Pelvic Supports by retightening
the M6 domed Nylock Nuts.
THORACIC SUPPORT ADJUSTMENTS
The Thoracic Supports are of the positive locking, swing-away style, currently
being successfully used on other RMS Gill Seating Systems, such as the Gill 3
Junior, Gill 3 and the Gill 4.
To enable the Supports to swing-away during
user transfers, depress the green lock button
located on the top of the Support Arms at the
rear of the Thoracic Pads, Fig.9a. The Pads
will then positively lock when returned to the
forward support position.
Having slotted mounting plates and two lines
of mounting holes, enables the Thoracic
Supports to be width and height adjustable on
the Backrest Panel. Fig.9b
Tools Required: 4mm Hexagon Key
[Cont]
14
Swing-away
lock buttons
Fig.9a
M6 Domed
Nylock Nuts
Fig.8a
Fig.8b
Support
Brackets