RMS Gill 2 Installation And User Manual - page 15
IMPORTANT NOTE: Unless specific dimensions have been requested with
the original order, the Thoracic Supports will be set to an average position
and may not be fully tightened. Therefore, correct positioning and security
will be necessary.
To adjust Thoracic Pad Height:-
1. To raise or lower the Thoracic Supports, remove the Velcro attached Backrest
Cushion from the Backrest Panel.
2. Using the 4mm Hexagon Key, remove the two M6 Hex. Head Mounting Screws
Fig.8b, securing the Thoracic Supports to the Backrest Panel.
(NOTE: Retain screws and key washers).
3. Move Thoracic Support to the required
Height, in line with the nearest mounting
holes in the Backrest Panel.
NOTE: Mounting holes have 25mm centres
vertically and 50mm centres laterally.
4. Whilst holding the Thoracic Support,
together with the two key washers, in the
required position on the front face of the
Backrest Panel, insert each retaining
screw through the appropriate hole in the
Backrest Panel and screw into the key
washers, ensuring that the key washers
are correctly located in the Thoracic
Support Mounting Brackets. (DO NOT
FULLY TIGHTEN at this stage).
5. Repeat the above for the opposite side.
Adjust Thoracic Pad Width as detailed
below.
To adjust Thoracic Pad Width:-
NOTE: It will not be necessary to carry out operations 1
—5, when adjusting the
width only.
6. To obtain the required Thoracic Support width, slacken both Mounting Screws
for each Support Fig.9b, using the 4mm Hexagon Key. Slide the Mounting
Brackets inwards or outwards, along their key washers, to the required position.
Whilst holding the Pads in the upright position, fully re-tighten all screws
sufficient to prevent any movement.
7. After completing any adjustments, ensure all screws are fully tightened sufficient
to prevent any movement. Re-attach the Backrest Cushion via the Velcro
panels.
15
Thoracic Support
Mounting Screws
Alternative
Mounting Positions
Fig.9b