RMS Gill 2 Installation And User Manual - Headrests
HEADRESTS
The Gill 2 Seating System, is fitted as standard, with an RMS Type D Headrest,
incorporating a Ball Mount, Angle Adjustable Stem with height pre-set collar and a
two screw fixing Backrest Mount. Correct positioning of the Headrest to suit
individual requirements, is normally achieved by a combination of adjustments.
Refer to Fig.10
Tools Required: 3, 4 and 5mm Hexagon Keys. 13mm Spanner.
To adjust Headrest Height:-
The Ball Mount built into the Headrest, enables the Headrest to swivel around the
ball. The three screws should be slackened to allow correct positioning and
always retightened evenly to maintain the Headrest position.
The Angle Adjustable Stem has two pivot points, both of which should be
slackened to enable the Headrest to be moved in a forward or rearward direction.
Fully tighten both M8 nuts sufficient to prevent any movement.
The overall height of the Headrest and Stem assembly, is locked-off by the Black
Thumb Screw located on the Stem Mount attached to the Backrest.
To enable the Headrest to be refitted to the same height each time after removal,
the Stem is supplied with a pre-set Height
Positioning Collar. This should be locked in place by it’s grub-screw, when all
other Headrest positioning adjustments have been completed. The Headrest
should therefore, always removed and refitted from the Receiver Mount as an
assembly.
Fig.10
RMS
Type “D”
Headrest
Pre-set
Height
Positioning
Collar
Angle Adjustable
Stem
Ball
Mount
Locking
Thumb
Screw
Headrest
Stem Receiver
Mount
16