S&P HR100V Installation And Wiring Instructions - page 13
Page 13
14. WIRING DIAGRAMS FOR FURNACE INTERLOCK SYSTEMS
STANDARD FORCED AIR
INTERLOCKING WIRING
A relay is normally used when tying
a ventilation system to the forced
air distribution system. Our Duotrol
System is equipped with an internal
relay that will activate the forced air
system’ ventilator when there is a
demand from the HRV . The Duotrol
System will activate the INTERLOCK
relay during the following modes:
Continuous, Override,Recirculation
and Defrost. See wiring diagram.
ALTERNATE FORCED AIR
INTERLOCKING WIRING
Some forced air system thermostat
will activate the cooling system when
tied using the «Standard forced air
interlocking wiring».
If you have identify this type of
thermostat you must proceed with
the «Alternate Forced Air Wiring».
LOCATING THE
WIRING DIAGRAM
NOTE TO INSTALLER: Wiring
Diagram for the entire line of HRV
Models are placed on the back of
each Exhaust motor bracket.
CAUTION: Thermostat that control
A/C system must use the Alternate
Interlock Wiring Diagram.
Low Voltage HRV Controller
Low Voltage HRV Controller
Thermostat
Legend: -------- Field Installed Low Voltage
Figure 14.1 Standard forced air wiring diagram
Figure 14.2 Alternate forced air wiring diagram
Legend: -------- Field Installed Low Voltage
Force Air System
Force Air System
*Before tying the HRV to a
forced air system, always
refer to system’s manual or
manufacturer.
WARNING: Always disconnect the unit prior to making any connections. Failure to disconnecting the power could result in electrical shock
or can damage the electronic boards, wall controls and/or unit.
CAUTION: Minimum wire requirements is LVT18 CSA/UL 4 strain to insure proper connection.