S&P HR100V Installation And Wiring Instructions - page 2
Page 2
IMPORTANT - PLEASE READ MANUAL BEFORE INSTALLATION
CONTENTS
TO REDUCE OR AVOID THE HAZARDS OF ELECTRIC SHOCK AND FIRE:
CAUTIONS CONCERNING THE OPERATION AND FULL EFFICIENCY OF THIS PRODUCT:
CAUTION: Do not install in a cooking area or connect directly to any appliance. Turn off all integral disconnects before servicing.
NOTICE: Prior to installing, serious consideration must be taken to insure this ventilation system will operate properly if integrated to
any other type of mechanical system, i.e. a forced air system, or an air handling unit. To insure proper operation & compatibilities of both
system, it is required that the airflow’s of the Heat Recovery Ventilator (HRV) be balanced, by following the procedures found in this
manual.
LIMITATIONS: The product is for residential applications only. Must be installed in accordance with all national and local regulations,
building and safety codes.
SECTION
PAGE
1. Ventilation requirements . . . . . . . . . . . . . . . . . . . 3
2. Fitting equivalent lengths . . . . . . . . . . . . . . . . . . 4
3. Types of Installations . . . . . . . . . . . . . . . . . . . . 5
4. Installation Kit . . . . . . . . . . . . . . . . . . . . . . . . 7
5. Finding a suitable installation area for HRV . . . . . . . . . 7
6. Installation of the HRV . . . . . . . . . . . . . . . . . . . . 7
7. Insulated Flex from Unit to Outside Wall. . . . . . . . . . . 8
8. Condensation Drain Line . . . . . . . . . . . . . . . . . . 8
9. Dedicated Electric Receptacle . . . . . . . . . . . . . . . 8
10. Outside Fresh Air and Exhaust Air Hoods . . . . . . . . . 9
11. The matrix™ High Performance Ventilation Hood . . . . . 9
12. Benefits of the Duotrol™ System. . . . . . . . . . . . . 10
13. Balancing the unit . . . . . . . . . . . . . . . . . . . . 10
14. Controls Connection . . . . . . . . . . . . . . . . . . . . 12
15. Wiring Diagrams for furnace interlock systems . . . . . . 13
16. Troubleshooting . . . . . . . . . . . . . . . . . . . . . 14
17. Maintenance . . . . . . . . . . . . . . . . . . . . . . . 15
18. Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . 15
• Before servicing or cleaning the HRV system, always remove the
power cord from the AC wall outlet.
• To reduce the hazards of electric shock or fire, do not perform
any service to the HRV system other than those stated in the
operating manual instructions.
• To reduce the risk of electric shock, this ventilation system (HRV)
comes equipped with a 3-prong plug-in. This plug will fit in a
polarized outlet only one way.
• Do not use ventilation system for outdoor application.
• Do not pull or twist power cord when disconnecting it from the
ventilation system. Grasp the plug firmly, not the cord.
• Do not modify the power plug in any way; if modified, risk of
electric shock fire or even damage to the unit may occur.
• Do not use the ventilation system for removal of flammable
fumes, gases or connect directly to any appliances.
• Use a dedicated AC 120V outlet only.
• Do not obstruct or cover the air intake or air outlet of the ventilation
system.
• Do not modify, repair or disassemble this system. These tasks
are to be performed by authorized serviced personnel only. Fire,
electrical shock and/or bodily injury may occur if these warnings
are not followed.
• To prevent injuries, do not operate the ventilation system, while
servicing or maintaining. There are impeller wheels turning at a
very high speed that must fully stop rotating prior to accessing
the inside of the unit.
• Always assess the operation of the ventilation system on how
it may interact with vented combustion equipment (ie. Gas
Furnace, Oil Furnace, Combustion, Appliances, etc.)
• Do not use for swimming pool/spa applications.