Saeco HD 8323 Operating Instructions Manual - page 19
• 19 •
English
the machine is too high for brewing coff ee.
• Prime the circuit as described in section 4.5 to make the
machine ready for use.
Note: the machine is ready when the
"ma-
chine ready" light is steady on.
Important note: if it is not possible to brew a
cappuccino as described, prime the circuit as
explained in section 4.5 and then repeat the steps.
The same procedure can be used to heat other
beverages.
• After this operation, clean the steam wand with a wet
cloth.
9 CLEANING
Maintenance and cleaning can only be carried out when the
machine is cold and disconnected from the electric network.
• Do not immerse the machine in water or place any of its
parts in a dishwasher.
• Do not use spirit, solvents and/or aggressive chemical
agents.
• We recommend cleaning the water tank and refi lling it
with fresh water every day.
• Clean the steam wand weekly. Wash the steam wand with
a wet cloth and remove any milk residue.
•
(Fig.28) -
Empty and clean the drip tray every day.
• Use a soft, dampened cloth to clean the appliance.
•
(Fig.17) -
Perform the following operations to clean the
pressurized fi lter holder:
-
(Fig.9)
- remove the fi lter and wash it thoroughly with hot
water.
- remove the adapter (if any) and wash it thoroughly with
hot water.
- wash the internal part of the pressurized fi lter holder.
• Do not dry the machine and/or its parts using a microwave
and/or standard oven.
•
(Fig.29) -
Clean the seat for accessories with a damp cloth
every week to remove any coff ee or dust residues.
Note: do not wash the pressurized fi lter holder
in the dishwasher.
10 DESCALING
Limescale builds up with the use of the appliance; the machine
needs descaling every 1-2 months and/or whenever a reduc-
tion in water fl ow is noticed. Use the Saeco descaling product
only.
In case of confl ict, priority must be given to
what is indicated in the operation and mainte-
nance manual over the instructions provided on sepa-
rately sold accessories and materials.
Use the Saeco descaling product (Fig. B). Its
formula has been designed to ensure better
machine performance and operation for its whole op-
erating life. If correctly used, it also avoids alterations
in the brewed product. Before starting a descaling cy-
cle make sure that: THE WATER FILTER (if used) HAS BEEN
REMOVED.
Never drink the descaling solution or any prod-
ucts dispensed until the cycle has been carried
out to the end. Never use vinegar as a descaling solu-
tion.
1 (Fig.10-11)
-
Insert the fi lter holder into the brew unit (8)
from the bottom and turn it from left to right until it locks
into place.
2 (Fig.1B)
-
Remove and empty the water tank.
3 (Fig.2)
-
Pour
HALF
the content of the Saeco concentrated
descaling solution into the water tank, then fi ll the tank
with fresh drinking water up to the MAX level.
4
Turn on the machine by pressing the ON/OFF button (11).
The indicator light (16) turns on.
(Fig.18)
-
Fill up (as described in chapter 7 of the manual)
2 cups of water (about 150 ml each) from the steam / hot
water wand and turn off the machine by pressing the
ON/
OFF button (11); the light (16) turns off
5
Let the descaling solution take eff ect for approx. 15-20
minutes with the machine turned off .
6
Turn on the machine by pressing the ON/OFF button (11).
(Fig.18) -
Fill up (as described in chapter 7 of the manual)
2 cups of water (about 150 ml each) from the steam / hot
water wand. Then turn the machine off by pressing the
ON/OFF button (11) and leave it off for 3 minutes.
7
Repeat the operations described in
step 6
until the water
tank is completely empty.
8 (Fig.2)
-
Rinse the water tank with fresh drinking water
and fi ll it completely.
9
Place a container under the fi lter holder.
10
Switch on the machine by pressing the ON/OFF button (11);
turn the selection knob (15) to the "
" position and, by
means of the fi lter holder, dispense the whole content of