Safety Vision PatrolRecorder 4C Installation Manual - page 5
PatrolRecorder
™
4C Installation Guide
October 2009
PATROLRECORDER 4C IG Ver 1.5.doc
5
Important Installation Precautions
Keep the following precautions in mind when installing
the PatrolRecorder™ 4C system:
IMPORTANT: To reduce the risk of electrical shock,
disconnect the vehicle negative battery terminal during
PatrolRecorder™ 4C system installation.
To prevent system damage, the main wiring harness
(Part Number SV-BHRNS) must not be connected to
the vehicle electrical system until all other components
and cables are installed and connected.
The ground wire of the main wiring harness (Part
Number SV-BHRNS) must be connected directly to the
vehicle chassis.
Use care when affixing any device to a vehicle with
screws. Before drilling or inserting screws, ensure that
vehicle components such as the gas tank and airbags
will not be damaged by the drill bit or screw.
To prevent system damage, use only the cables
supplied with the PatrolRecorder™ 4C system.
Do not disassemble any component of the
PatrolRecorder™ 4C system.
Typical Installation
MDVR Installation
The MDVR is designed to be flush-mounted in the vehicle
equipment console, using the supplied flush-mount
bracket (Part Number SV-LS-CONSOLEMT) and the 2
supplied 10-32 x 1/4 panhead screws, as follows:
Ï Flush-Mount (Console) Installation
An optional surface-mount bracket (Part Number
SV-LSBRKT) is available, making the MDVR mountable
elsewhere in the vehicle, either vertically or horizontally
(on the floor or ceiling), as follows:
Ï Surface-Mount Installation Using Optional Bracket
Monitor Installation
The monitor is designed to be mounted overhead or
elsewhere in the vehicle cabin (including on the floor or
console). The mounting surface should:
Be level, waterproof, ventilated adequately, and
capable of supporting the weight of the monitor and
mounting bracket
Not be close to a vehicle speaker (to prevent
interference from the speaker’s magnetic field)
Not be extremely hot or humid