SAGEMCOM Seen User Manual - Seen – Seen A
Seen – Seen A
18
A
NSWERING MACHINE SETUP
(M
ODELS
S
EEN
A
ONLY
)
Modify the answering machine mode
1.
Go to the menu "
ANS. MACHINE
" "tam settings" "ANSWER MODE".
2.
Select "ANS & REC" or "Answer only" using the or
key to activate or deactivate your
answering machine, press
. A confirmation beep is issued.
Modifying the outgoing message (OGM)
Recording a personal outgoing message
1.
Go to the menu "
ANS. MACHINE
""tam settings" "Ogm settings" "ANS & REC" (or "ANSWER ONLY").
2.
Select "RECORD Mess" using the or key, press
.
3.
Record your message.
4.
At the end of your message, press
.
A beep will confirm that your message is now being used.
If you make a mistake while recording the message, repeat the operations described above until
you are satisfied with your message.
The recording of a new message will automatically replace the previous
message
.
The maximum recording duration for a message is 180 seconds.
The recording start and end beeps are not part of your message
.
Listening to your answer machine message
1. Go to the menu "
ANS. MACHINE
""tam settings" "Ogm settings" "ANS & REC" (or "ANSWER ONLY").
2. Select "playback" using the or key, press
.
3. Your current answer machine message will be played. Your handset will automatically return
to the previous menu.
If you have not saved a personal message, the answering machine will
automatically use the pre-recorded message.
Number of rings
This parameter enables you to set the number of times your telephone rings before the answering
machine answers a call. The number of rings can be set between 2 and 8.
You can also select the "time saver" mode. The "time saver" mode automatically determines the
number of rings: If there are no new messages on the answering machine, the number of rings
will be 4, otherwise the number of rings will be 2.
1. Go to the menu "
ANS. MACHINE
""tam settings" "answer delay ".
2. In the list, select the desired number of rings (between 2 and 8) using the or keyor the
" time saver " mode, press
.
Recording time of incoming messages
Define the maximum time a caller has to leave their message.
1. Go to the menu "
ANS. MACHINE
""tam settings" "record time ".
2. Choose the desired recording time (60 s, 120 s, 180 s or unlimited) by using keys or ,
then
press
.