SAGEMCOM Seen User Manual - Seen – Seen A
Seen – Seen A
19
Remote access control
This function allows you to check your voice messages and change your answer machine
settings even when you are not at home.
Activate/deactivate remote access
1. Go to the menu "
ANS. MACHINE
""tam settings" "remote acc.".
2. Use or to select " on " or " off " setting.
3. Press
key to confirm your selection. You will hear a confirmation tone.
By default, the remote enquiry function is activated. You should modify the
remote enquiry code (0000 by default).
It can be modified from the ANS. MACHINE tam settingschange pin menu (refer to
the paragraph “Modify the remote enquiry code” page 19)
.
Remote access control
To remotely access your answering machine: dial your telephone number and wait for the
answering machine to come on. When your outgoing message is played, press and enter your
remote access code (0000 by default).
If no key is pressed for 5 seconds, the answer machine will stop automatically.
A beep will indicate access to the answering machine. You can carry out the following operations:
Key
Action
Key
Action
4
- 1 press: return to beginning of the
message.
- 2 presses: return to previous message.
2
Delete the current message.
5
Start playback of the messages.
9
Switch OFF the answering machine.
6
Go to the next message.
7
Activate the answer machine.
8
Stop playing the messages.
Modify the remote enquiry code
With the enquiry code you can make remote access to your answer machine messages secure
from another telephone.
By default, the remote enquiry function is activated. You should modify the
remote enquiry code (0000 by default).
1.
Go to the menu "
ANS. MACHINE
""tam settings" "change pin".
2.
Enter the remote enquiry code (0000 by default) using the keys on the keypad. Press
.
3.
Enter the new remote enquiry code, press
.
4.
Enter the new remote enquiry code a second time, press
to confirm deletion.
A confirmation beep is issued.