Sailor UAIS1900 Technical Manual - page 11
UAIS DEBEG 3400, Electronics Unit
ED3047G142 / 08 (2004-06)
Technical Manual
1 General
1.1 Software Releases
t_ue_e01.fm / 21.06.04
11
1
General
This Technical Manual is the technical reference manual for the following components:
-
UAIS DEBEG 3400 Electronics Unit
The manual contains further information about the antennas (GPS, VHF).
1.1
Software Releases
This manual is valid for all software versions of the UAIS DEBEG 3400. A new software version will be
published only if the current version contains any faults. See also Section 5.2.
1.2
General Recommendations for Installation, Maintenance and Repair Work
SAM Electronics gives advice and recommendations for the arrangement of SAM Electronics equipment
and the installation sites. A prerequisite is that the necessary drawings of the ship should be made avail-
able in good time.
This advice and these recommendations are given on the basis of our up-to-date practical experience
and to the best of our knowledge. However, they are given without any commitment. As far as is permis-
sible, any liability on the part of SAM Electronics for resulting damage is expressly ruled out, regardless
of whether the damage is of a direct or indirect nature.
Unusual shipbuilding shapes, additions or superstructures as well as environmental influences can impair
the functioning of the equipment. We are, of course, willing to help the customer with optimizing solutions
subject to suitable commercial arrangements.
The customer is responsible for ensuring that SAM Electronics equipment is installed properly according
to our instructions and in compliance with the regulations issued by the relevant classification society and
national authorities.
1.3
Safety Warnings
The discharge of electrostatic energy into a semiconductor can destroy the semiconductor or change its
properties. Before a unit’s housing is opened to remove or touch a board, the service equipment, Order
No. 586-5011, must be used.
1.
The mat must be positioned at the workplace.
2.
The potential equalization cable must be connected to the snap fastener and the clamp to a suitable
protective earth contact. The cable contains a 1 M
Ω
resistor which must not be removed.
3.
The wrist band must be put on. When the spiral cable is connected to the snap fastener, the
discharge line is established.
WARNING
This unit contains electrostatic sensitive devices.
Observe precautions for handling.