Sailor UAIS1900 Technical Manual - page 79

UAIS DEBEG 3400, Electronics Unit

ED3047G142 / 08 (2004-06)

Technical Manual

8  Fault Code List

t_ue_e09.fm / 21.06.04

79

-

AIS Trans-

mitter Off

No transmis-

sion

AIS TRANSM. 

OFF

Generated by: AIS Electronics Unit

Cause/Source: The transmitter has been switched off 

completely by the operator, the MMSI number has not 

been configured in the Configuration menu or an error 

appeared which caused a stop of transmission (time out of 

7 minutes).

Reaction: The Electronics Unit continues operation.

Remedy: The transmitter must be switched on (see the 

Operating Instructions of the DCU) or the MMSI number 

must be configured. If it has not been configured before-

hand, it is set to 0 and no data is transmitted.

Remedy: Check other error messages to find the reason 

for the alarm. If there are no further messages, restart the 

Electronics Unit by disconnecting the mains supply. 

-

-

SET GYRO 

required

-

Generated by: AIS Gyro Interface

See the Operating Instructions

Fault

Messages at

Error Message generated by,

Possible Cause/Source,

Reaction of the System,

Remedy

1000 Series, 

CHART-

PILOT, MULTI-

PLOT 910x  

(Chart Mode)

DCU

Radar 9xxx, 

MULTIPILOT 

910x (Radar 

Mode)