Sailor UAIS1900 Technical Manual - page 76
UAIS DEBEG 3400, Electronics Unit
ED3047G142 / 08 (2004-06)
Technical Manual
8 Fault Code List
t_ue_e09.fm / 21.06.04
76
025
AIS: External
EPFS lost
(EPFS = Elec-
tronic Position
Fixing System
such as GPS)
External
EPFS lost
AIS
EXTERNAL
EPFS
Generated by: AIS Electronics Unit
Cause/Source: No valid position data at interface S1, S2,
S3
Reaction: The Electronics Unit continues operation with the
position data of the internal position sensor. If there is no
valid position data available from the internal position
sensor, additionally error 026 is displayed.
Remedy: The telegrams GLL, GNS, GGA, RMC can not be
received. Check the sensor and the cabling; Check if the
system that delivers the data is working (RADARPILOT
1000); Check the baud rate settings of the sensor inputs.
026
AIS: No sensor
position in use
No sensor
position in use
AIS NO POSI-
TION
Generated by: AIS Electronics Unit
Cause/Source: No valid position from internal position
sensor
Reaction: The Electronics Unit continues operation.
Remedy: Check the cabling and the antenna of the internal
GPS sensor.
029
AIS: No valid
SOG informa-
tion
No valid SOG
information
AIS NO SOG
Generated by: AIS Electronics Unit
Cause/Source: No data from external sensor and from
internal position sensor
Reaction: The Electronics Unit continues operation.
Remedy: The telegrams VBW, VTG, RMC can not be
received. Check the sensor and the cabling; Check if the
system that transmits the data is working (RADARPILOT
1000); Check the baud rate settings of the sensor inputs.
030
AIS: No valid
COG informa-
tion
No valid COG
information
AIS NO COG
Generated by: AIS Electronics Unit
Cause/Source: No data from external sensor and from
internal position sensor
Reaction: The Electronics Unit continues operation.
Remedy: The telegrams VTG, RMC can not be received.
Check the sensor and the cabling; Check if the system that
transmits the data is working (RADARPILOT 1000); Check
the baud rate settings of the sensor inputs.
032
AIS: Heading
lost/invalid
Heading lost/
invalid
AIS NO
HEADING
Generated by: AIS Electronics Unit
Cause/Source: No data from external sensor
Reaction: The Electronics Unit continues operation.
Remedy: The telegrams HDT can not be received. Check
the sensor and the cabling; Check if the system that trans-
mits the data is working (RADARPILOT 1000); Check the
baud rate settings of the sensor inputs.
Fault
Messages at
Error Message generated by,
Possible Cause/Source,
Reaction of the System,
Remedy
1000 Series,
CHART-
PILOT, MULTI-
PLOT 910x
(Chart Mode)
DCU
Radar 9xxx,
MULTIPILOT
910x (Radar
Mode)