Sailor UAIS1900 Technical Manual - page 39
UAIS DEBEG 3400, Electronics Unit
ED3047G142 / 08 (2004-06)
Technical Manual
4 Functional Description
4.3 Description of the Components
t_ue_e04.fm / 21.06.04
39
Input sentences in compliance with IEC 61162-1/-2
NOTE:
If the AIS Electronics Unit receives the ship’s sensor data from Ship’s Interface, the output interfaces of
the Ship’s Interface must be configured as follows:
-
Select "IEC 61162-1 edition 2/2000 (NMEA 2.3)" as driver
-
Set a repetition interval of 1 s for the following telegrams: GLL, VTG, HDT, ROT, VBW
4.3.1.4
Supported Sentences for the AIS Primary Display Port and the Pilot Port
Input
Input sentences in compliance with IEC 61162-1/-2
Data
Required Sentence
(Identifier and Description)
Optional Sentence
(Identifier and Description)
Reference Datum
DTM (Datum reference)
Positioning System:
- Time of Position
- Latitude/Longitude
- Position accuracy
- GNS (GNSS fix data)
- GLL (Geographic position latitude/
longitude)
- RMC (Recommended minimum
specific GNSS data)
Speed over Ground (SOG)
- VBW (Dual ground/water speed)
- VTG (Course over ground and ground
speed)
- RMC (Recommended minimum
specific GNSS data)
Course over Ground (COG)
- RMC (Recommended minimum
specific GNSS data)
- VTG (Course over ground and ground
speed)
Heading
- HDT (Heading, true)
RAIM indicator
- GBS (GNSS satellite fault detection)
Rate of Turn (ROT)
- ROT (Rate of turn)
Data
Sentence Identifier/Description
Normal Access - Parameter Entry
Voyage information:
- Vessel type and cargo category
- Navigational status
- Draught, max. actual static
- Destination
- ETA date and time
- Regional application flags
VSD (Voyage static data)
Station information:
- Vessel name
- Call sign
- Antenna location
- length and beam
SSD (Station static data)
Initiate VHF Data Link Broadcasts
Safety messages
ABM (Addressed binary message)
BBM (Broadcast binary message)
Binary messages
ABM (Addressed binary message)
BBM (Broadcast binary message)
Interrogation message
AIR (AIS interrogation information)
AIS Equipment - Parameter Entry