Saivod Sap 685 Instruction Manual - page 10
OPERATION for electronic type
Control panel
18
17
16
15
11
10
9
8
7
5
4
2
14
13
12
6
3
1
TIMER
MODE
DOWN
SPEED
UP
I/O
FIG.17
1. I/O(power)button
2. Compressor operation indicator
3. Speed(ventilation)button
4. Low ventilation indicator
5. High ventilation indicator
6. Mode(function)option button
7. Automatic mode indicator
8. Cooling mode indicator
9. Fan mode indicator
10. Heating mode indicator(for cool & heat
model only)
11. Timer button
12. Timer operation indicator
13. `Temperature down` button
14. `Temperature up` button
15. Receiver for Remote Control
16. Display window
17. `Room temperature indicator
18. `Set temperature indicator
Turning ON/OFF
Press ON/OFF button, the unit will start automatically. If the ambient temperature is
- higher than 23
o
C, the unit will work in cooling model.
- higher than 20
o
C but below or equal to 23
o
C, the unit will work in ventilation model.
- below 20
o
C, the unit will work in heating function (This is for cooling & heating
models only.),
Indicators of the functions in progress come on at the same time. *NOTE! The
COMPRESSOR indicator will only light up as the compressor is in operation.
The display window shows the ambient room temperature.
To turn the unit off, press ON/OFF button again.
Setting mode/function
Press MODE button to select required working mode: automatic, cooling, fan or heating,
(Heating is only available for heating & cooling models.)
The indicator of your selected mode comes on.
Setting temperature
Press 'Temperature up' or 'Temperature down' button to regulate the temperature you
desired.
The display window will show the temperature you set as you press 'Temperature up' or
'Temperature down' button. Otherwise, it will always show the ambient temperature.
The pre-setting temperature of this machine is: 24
o
C for cooling, 20
o
C for heating.
9