Saivod Sap 685 Instruction Manual - Drainage
.
DRAINAGE
During the process of cooling, some water will be extracted from the air into the unit. If
the reservoir is full:
a. For mechanical type, the compressor will stop, only the fan to circulate the air. The
'FULL WATER' indicator will light now to remind you.
b. For electronic type, both of the compressor and motor will stop. The COMP.
indicator will flash to show you.
To make the cooling work again, please empty the water by one of the following ways:
1.
Turn off the air conditioner and avoid
moving it when full.
2. Position a container (a water tray for
example) underneath the drain hole.
3. Remove the drain knob & rubber plug
from the drain hole and allow the water
to drain out.
4.
When the container is almost full,
replace the rubber plug in the drain hole
and empty the water tray.
5.
Repeat until the unit is emptied.
6. Replace the rubber plug and tighten the
drain knob firmly.
7. Switch on the unit - the full water or
compressor operating indicator should
not be flashing.
FIG.20
If you wish to operate the unit without the need to empty the water tank, please:
Remove the drain knob and rubber
plug and retain for future use.
Connect the drain tube supplied to the
water outlet as shown and locate the
other end into a drain.
The drain tube may be extended by
adding an extension tube and using a
suitable connector.
Rubber plug
Drain knob
FIG.21
Drain tube
FIG.22
11
Water hole
Rubber plug
Drain knob