Salicru SPS.ONE User Manual - page 8
7
SALICRU
5.5.
CONNECT COMMUNICATION CABLE.
To allow for unattended UPS shutdown/start-up and status moni-
toring, connect the communication cable one end to the USB port
and the other to the communication port of your PC. With the moni-
toring software installed, you can schedule UPS shutdown/start-up
and monitor UPS status through PC.
5.6.
TURN ON / OFF ThE UNIT.
Turn on the UPS unit by pressing the power switch
.
Turn off the
UPS unit by pressing again the power switch.
6. IMPORTANT SAFETY WARNING.
SAVE ThESE INSTRUCTIONS
CAUTION! To prevent the risk of fire or electric shock, install in a
temperature and humidity controlled indoor area free of conductive
contaminants. (See the specifications for the acceptable tempera-
ture and humidity range.)
CAUTION! To reduce the risk of overheating the UPS, do not cover
the UPS’ cooling vents and avoid exposing the unit to direct sunlight
or installing the unit near heat emitting appliances such as space
heaters or furnaces.
CAUTION! Do not attach non-computer-related items, such as
medical equipment, life-support equipment, microwave ovens, or
vacuum cleaners to UPS.
CAUTION! Do not plug the UPS input into its own output.
CAUTION! Do not allow liquids or any foreign object to enter the
UPS. Do not place beverages or any other liquid-containing vessels
on or near the unit.
CAUTION! In the event of an emergency, press the OFF button and
disconnect the power cord from the AC power supply to properly
disable the UPS.
CAUTION! Do not attach a power strip or surge suppressor to the
UPS.
CAUTION! If the UPS is with metal chassis, for safety purpose,
grounding is a must during UPS installation in order to reduce
leakage current below 3.5mA.
Attention hazardous through electric shock. Also with discon-
nection of this unit from the mains, hazardous voltage still may be
accessible through supply from battery. The battery supply should
be therefore disconnected in the plus and minus pole at the quick
connectors of the battery when maintenance or service work inside
the UPS is necessary.
CAUTION! Servicing of batteries should be performed or super-
vised by personnel knowledgeable of batteries and the required
precautions. Keep unauthorized personnel away from batteries.
CAUTION! When replacing the batteries, use the same number
and type of batteries.
CAUTION! Internal battery voltage is 12V
DC
. Sealed, lead-acid,
6-cell battery.
CAUTION! Do not dispose of batteries in a fire. The battery may
explode. Do not open or mutilate the battery or batteries. Released
electrolyte is harmful to the skin and eyes.CAUTION! Unplug the
UPS prior to cleaning and do not use liquid or spray detergent.
CAUTION! A battery can present a risk of electric shock and high
short circuit current. The following precaution should be observed
before replacing batteries:
Remove watches, rings, or other metal objects.
1.
Use tools with insulated handles.
2.
Wear rubber gloves and boots.
3.
Do not lay tools or metal parts on top of batteries.
4.
Disconnect charging source prior to connecting or disconnec-
5.
ting batteries terminal.