Salora CDC1300FD Manual - page 37

36

Installation

1. Insert a memory card: insert the memory card, in accordance with the opening of the slot, press the 

card until it clicks.

_________________________________________________________________________

Please note that the device operates with High speed storage, we advise you to use a high speed 

memory card, (Class 6 or higher)

Note: the first time you will be using a memory card be sure to format the card.

2. Remove the memory card: press the card until it comes out of the slot automatically.

Note: If the device is in the boot state, do not remove the card, in order to avoid damaging the 

memory card.

3. The screen is mounted on the front windshield inside the vehicle.

(1). The device is mounted on the suction cup bracket, tighten the base holder with the suction cup, 

make sure the camera is level with the ground, check if the device is firmly locked in place.

(2). Check if the suction cup is flat on the windshield.

(3). Firmly place the suction cup on the windscreen, pressure the clamps, the holder is mounted on the 

rear-view mirror in front of the windshield. Check if the device is firmly locked in place.

4. Connect the power

Please use the original standard charger supplied, the boot device and the built-in battery. The end of the 

charger cable is connected to the device’s USB port, the other end is plugged into the car port. Once the 

car engine is started, the device will automatically boot.

_________________________________________________________________________

Note: you can extend the line of the device along the sides of the windshield and dashboard, so 

that the cable is not visible.