Salora CDC1300FD Manual - page 46
45
USB functions
1 : USB disk 2 : PC-Camera
Power Interface
5V 1A
Battery
Built-in 200mAh
____________________________________________________________________________________________
Troubleshooting
In case of any malfunctions or problems with the device, please refer to the possible solution mentioned here below:
Unable to boot
Check if the device is correctly connected to the car, check if the device has been manually been turned on, check if
the battery has enough power or if it needs recharging. Sometimes it is necessary to reset the device and restore to
the factory settings.
The camera stops automatically and the loops cannot be recorded.
Due to high definition recordings, it could be possible that the memory card does not function correctly, try a memory
card of a higher class, such as class10.
If the segments cannot be recorded, it could be possible that you have activated the G sensor, so that the memory
card is filled with locked files. You can format the card, so that the files will be deleted and deactivate the G sensor.
The camera recordings and the segments are not the same.
Check if the motion detection function is activated, the length of time of those segments, depend on the detection of
the motion of the vehicle and will be recorded only if a motion has been detected.
The recorded movie is not clear.
Check, whether the camera has no fingerprints on it. Please clean the lens before shooting and wipe the lens
regularly.
The recorded video is of bad quality
The quality of the video can depend on numerous external circumstances, backlight, sunlight, intensity of the light,
some can be adjusted by modifying the settings in the menu.
There is a streak interference on the images.
You could try to modify the settings of the light frequency, the normal rate is 50HZ.