Salton EX1222 Instruction booklet - Troubleshooting
TROUBLESHOOTING
10
PROBLEM
SOLUTION
1. Coffee does not flow.
• Remember to fill Reservoir or Boiler with
water before machine is switched On.
• Check if Switch is On.
• Use a coarser grind of coffee.
• Reduce the amount of coffee in the Espresso
Filter. Do not compact coffee in the Filter.
2. Coffee is too weak or flows
too quickly.
• Use a finer grind of coffee.
• Increase the amount of coffee in the Filter
3. Coffee flows too slowly or is
too strong.
• Use coarser grind.
• Reduce the amount of coffee in the Filter.
• Follow the Descaling instructions in this
booklet.
4. Coffee flows from the edge
of the Filter Holder
• NOTE: Allow machine to cool completely.
• Wipe excess grinds from the Filter Holder.
• Make sure the Filter Holder is installed
securely in the 'Lock' position.
5. No steam from the Steam
Tube or steam stops before
frothing is complete.
• NOTE: Allow machine to cool completely.
• Remember to fill the Boiler.
• Check if the switch is On.
• Make sure that the Steam Control Knob is in
the Steam position (steam cloud symbol).
• Close the Steam Control Knob, remove and
wash the Rubber Frothing Nozzle and Steam
Nozzle. Replace, then try again.
6. Steam escapes from the
Boiler Cap area.
• This is the normal functioning of the
pressure regulating device.
Booklet_EX1222_ENG_Salton Booklet 3/28/12 1:44 PM Page 10