For other language versions, please visit: www.Salusinc.Com optima zigbee thermostat quick start guide.
1 l et ’ s get started . Make sure you have the following items: thermostat with mounting plate trim plate screws and anchors wire labels 2 x aa alkaline batteries user’s manual quick start guide.
2 turn off the heating and/or cooling turn off the breakers or remove the fuses to the heating and/or cooling systems at the electrical panel. In some regions, there may be a switch located near the furnace..
3 determine wiring configuration • remove the old thermostat to expose the wiring terminals. • take a picture of the wiring for future reference. • note the terminals attached to each wire and attach the matching label to the ends of the wires. Use the following table as a reference. * a jumper conn...
4 remove old thermostat terminals remove the old thermostat wiring terminals from the wall, taking care not to allow the wiring to fall inside the wall. Install mounting plate remove the mounting plate from the back of the optima thermostat. Use the included wall anchors and screws to attach the mou...
5 install batteries insert the alkaline batteries into the back of the thermostat. Make sure the polarity of the batteries is correct. After inserting the batteries, the display will flash all the segments, followed by the version number of the firmware, then display us / ca with a blinking us. Init...
6 attach thermostat to mounting plate attach the thermostat to the mounting plate by aligning the connector pins and the plastic retention posts and pushing the thermostat onto the mounting plate. Make sure the connector pins are not bent and that the thermostat is fully seated on the mounting plate...
7 s alus w arranty salus controls inc. (“salus”) warrants that for a period of two (2) years (“warranty period”) from the date of purchase by the consumer (“customer”), this device, excluding batteries (“product”), shall be free of defects in materials and workmanship under normal use and service in...
8 duration of implied warranties of merchantability or fitness, so these exclusions or limitations may not apply to you. No oral or written information or advice given by salus or a salus-authorized representative shall modify or extend this warranty. If any term is held to be illegal or unenforceabl...
9 fcc statements warning: changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this ...
10 fcc and industry canada rf radiation exposure statement: this equipment complies with fcc and industry canada rf radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the antenna and a...
Version 1.0 salus controls inc. 123 townsend st. Level ll2 san francisco, ca 94107.
