Salus OPTIMA ZigBee Quick Start Manual - Install Mounting Plate
4
Remove old thermostat terminals
Remove the old thermostat wiring terminals
from the wall, taking care not to allow the
wiring to fall inside the wall.
Install Mounting Plate
Remove the Mounting Plate from the back of
the Optima thermostat. Use the included wall
anchors and screws to attach the Mounting
Plate to the wall, making sure the wires run
through the center opening. Use the Trim Plate
vertically or horizontally if desired.
Attach Wiring
Before attaching the wires, match the wire
(using the labels) to its corresponding
terminal. Refer to the picture of the wiring
taken earlier if necessary.
• Open the terminal by lifting the latch up.
• Push each wire into the hole of the
terminal and push the latch down to
secure the wire.
TIP: Wrap the wire ends
around a long stick, such as
a pencil to keep the wires
from falling into the wall.