Salute Superior Super Blender Owner's Manual - page 2
Congratulations on your excellent choice. Your Saluté Superior Super Blender
will make a huge difference to your lifestyle and your health. The Saluté allows
you to convert fruit, vegetables into deliciously healthy treats in seconds and
also supports the processing of dry materials. The Saluté carries a 3 year
warranty on the motor and 1 year on other parts.
The warranty does not reflect the years of dependable service offered by this
Superior Super Blender.
Email :
service@conglomus.co.za
What you can make with your New Saluté
Superior Super Blender
- Green Juice
- Melt Cheese or Chocolate
- Dips and Pâté
- Pesto
- Hummus
- Guacamole
- Grind Coffee Beans
- Breadcrumbs
- Frozen Treats
- Churn Herb Butter from
Fresh Cream
- Sorbets
- Purées
- Frappe Fabulous Coffee
- Grind Herbs & Spices
-
Green Smoothies
- Fruit Smoothies
- Savoury Smoothies
- Hot Raw Soup
- Cooked Soup
- Creamy Nut Butters
- Baby Foods
- Whipped Cream
- Sauces and Dressings
- Crush Ice
- Batter
- Grind Grains
- Raw Desserts
• Make Coleslaw
1.
After each use, rinse the jug thoroughly with warm
water, not hot.
2.
Place one to two drops of dishwashing liquid into
your jug and fill it halfway with warm water.
3.
Secure the lid with the lid plug in the locked position.
4.
Start the machine on Min speed, slowly increase to
Max with the Speed control knob.
5.
Run for about one minute.
6.
Empty the jug out and rinse thoroughly.
7.
Turn the jug upside down and let it air dry.
8.
For a deep clean, perform the following steps
monthly or as needed: Place 4 cups of cool water
and 4 cups of white vinegar into the container and
let it soak for about four hours. Pour contents out
and rinse thoroughly. Then follow the appropriate
cleaning instructions above.
Cleaning Your Saluté
The Saluté cut out while I was processing
Possible Cause 1:
The machine has probably overheated and cut out. Your Saluté is engineered with an automatic thermal
overload protection mechanism to prevent the motor from burning out.
Reasons for overheating:
1. Processing heavy materials for too long.
2. Processing heavy materials on too slow a speed.
3. Processing too much heavy material that does not contain liquid.
Solution:
1. Press the reset switch at the rear of the machine.
2. Leave the machine off for 10 – 30 minutes to cool down. (The cool down period is dependent on the
ambient temperature). If the machine is still not working, check Possible Cause 2.
Possible Cause 2:
Please check the obvious options such as faulty plug connections. If the machine is not working, contact
customer care.
I damaged the tamper/blade
1. I put the tamper into the jug with the lid off and it hit the blade
2. I used another utensil instead of the pusher and it hit the blade. The blade stopped turning / the tamper
is damaged
Solution:
The drive socket (the mushroom-looking thing that sits in the middle of the black rubber mat on the base) has
been damaged. This is a safety mechanism to stop the blades from causing further damage.
Order a new drive socket from www.healthmakers.co.za/store This is a DIY repair with tools and instructions.
If the blade is damaged then a complete blade-set needs to be replaced.
Customer Care:
service@conglomus.co.za
or complete the Service Form available at
www.healthinfocentre.co.za
Troubleshooting
SAFETY WARNING
To ensure safety unplug the power cord before cleaning the base. Never immerse the motor
base in water and never clean the blade assembly with your bare hands