Samson 5825 Mounting And Operating Instructions - page 7
EB 5824-1 EN
7
Safety instructions and measures
Revisions and other modifications
Revisions, conversions or other modifications to the product are not authorized by SAMSON.
They are performed at the user's own risk and may lead to safety hazards, for example. Fur-
thermore, the product may no longer meet the requirements for its intended use.
Safety features
Upon power supply failure, the Type 5825 Electric Actuator causes the valve to move to a
certain fail-safe position. The fail-safe action of SAMSON actuators is specified on the actua-
tor nameplate.
Warning against residual hazards
To avoid personal injury or property damage, plant operators and operating personnel must
prevent hazards that could be caused in the control valve by the process medium, the operat-
ing pressure, the signal pressure or by moving parts by taking appropriate precautions. They
must observe all hazard statements, warning and caution notes in these mounting and oper-
ating instructions, especially for installation, start-up and service work.
Responsibilities of the operator
The operator is responsible for proper operation and compliance with the safety regulations.
Operators are obliged to provide these mounting and operating instructions to the operating
personnel and to instruct them in proper operation. Furthermore, the operator must ensure
that operating personnel or third persons are not exposed to any danger.
Responsibilities of operating personnel
Operating personnel must read and understand these mounting and operating instructions as
well as the specified hazard statements, warning and caution notes. Furthermore, the operat-
ing personnel must be familiar with the applicable health, safety and accident prevention
regulations and comply with them.
Referenced standards and regulations
The Type 5824/5825 Electric Actuators comply with the requirements of the Directives
2014/30/EU and 2014/35/EU. The declaration of conformity includes information about
the applied conformity assessment procedure. This declaration of conformity is included in
the Appendix of these instructions.
The Type 5824/5825 Electric Actuators are designed for use in low voltage installations.
Î
For wiring, maintenance and repair, observe the relevant safety regulations.